Replaced start, stop button and lamp. Welded and fixed the blade guide under the table. New protective ball bearing behind the blade.

Replaced packing boxes in the mixer gearbox Welded mixer arm Fixed bushing for mixer arm Painted engines and gearboxes

All advanced control is disconnected. Slice thickness is controlled by air-pressured control

Test driven New condition Brass nut missing a pin

Mounted cutoff on-off Replace main power switch Renovated welding beam The machine runs with an external vacuum pump or central vacuum (pump not included, can be purchased separately) Welding beam: 80x70cm The conveyor belt is included

Test driven, runs fine!

New foot pedal installed. New relay and engine protection. Otherwise very good condition.

Test drive works great. Very little use, mint condition.

The machine has been inspected and is in good condition. A move. optional tool included that we have in stock. 115mm, 65mm, 40mm or 35x100mm

Installed another vacuum pump. Directed hook Fixed the twister Going well 👍

All buttons replaced A contactor replaced Manufacturing miscellaneous Levers, etc Test drive

Frying /Fryer/Cooking - top condition! Barely used, has been in warm storage. "With VarioCooking Center MULTIFICIENCY®, Frima VCC you can cooking, roasting, roasting, low-temperature cooking, confectionery, sous-vide cooking... without supervision, without burning, without the stress of handling pots and pans."

Works well

Compressor picked out

Test drive and review

Painted engine compartment Renovated electrical cabinet Review light curtain, one light curtain replaced with a new one. New start and stop buttons. Installed new engine Change the gaskets in one of the mixer arms.

New input and output bands New knife Works perfectly

Changed thermo cable to sensor for electric cartridges. Change vacuum oil Replace compressed air filter 4-5 pallets of trays are included
Moulds: 140x220, 140x250mm

Overhauled works good Trough: 160x230mm

New shaft + bearing slave side conveyor belt. 3 new heating cartridges. New feeder cable. New door for electrical cabinet. New inlet and outlet curtains

Replace air distributor Replace welding tape Change the oil Fixed connectors for pinch protection Double weld + cut off

Test run OK

Painted engine and gearbox New side plastic New curtain Works well

Change the oil Replace welding tape Change silicone strip Replace lid seal Vacuum value 7

Test run OK Variable lifting height 140-200cm

Renovated the buttons Fixed hydraulic system Replace sensor

Test drive and review Works perfectly

Change one sensor

Testrun good working order