Test drive and review

Replaced start, stop button and lamp. Welded and fixed the blade guide under the table. New protective ball bearing behind the blade.

New input and output bands New knife Works perfectly

Made missing press tools Change a button Rust-protected misc. Inside Welded feet.

Replaced packing boxes in the mixer gearbox Welded mixer arm Fixed bushing for mixer arm Painted engines and gearboxes

Mounted cutoff on-off Replace main power switch Renovated welding beam The machine runs with an external vacuum pump or central vacuum (pump not included, can be purchased separately) Welding beam: 80x70cm The conveyor belt is included

All buttons replaced A contactor replaced Manufacturing miscellaneous Levers, etc Test drive

Frying /Fryer/Cooking - top condition! Barely used, has been in warm storage. "With VarioCooking Center MULTIFICIENCY®, Frima VCC you can cooking, roasting, roasting, low-temperature cooking, confectionery, sous-vide cooking... without supervision, without burning, without the stress of handling pots and pans."

Painted engine compartment Renovated electrical cabinet Review light curtain, one light curtain replaced with a new one. New start and stop buttons. Installed new engine Change the gaskets in one of the mixer arms.

New shaft + bearing slave side conveyor belt. 3 new heating cartridges. New feeder cable. New door for electrical cabinet. New inlet and outlet curtains

Replace air distributor Replace welding tape Change the oil Fixed connectors for pinch protection Double weld + cut off

Test run OK

Test run OK Variable lifting height 140-200cm

Serviced, oil change and Teflon tape.

Brand new!

Test driven, runs good

Changed oil and oil filter. New locking mechanisms (x2) for the hatch to the engine compartment, 1 better used welding beam (modified), New welding wires and tape on the welding beams, New connectors to the welding beam New rubber seal for the lid, New screen part, Aligned the lid, Changed tires,

New main switch New buttons New limit switch mechanism New connection cable Mounted protection over chain Test run works well

Works good

Test run works well Mounted pressure regulator Fixed alarm tower Band width: 20cm Product height: 10cm

Test drive works fine 👍

Test drive works fine

Test driven, new condition. Machine used about 10 times Welding beams 2x62cm New warranty still applies. Also prepared for gas, can be run without gas as well.

Works well

Compressor picked out

All advanced control is disconnected. Slice thickness is controlled by air-pressured control

New foot pedal installed. New relay and engine protection. Otherwise very good condition.

Change the oil Replace welding tape Change silicone strip Replace lid seal Vacuum value 7