New foot pedal installed. New relay and engine protection. Otherwise very good condition.

Works well

Compressor picked out

Renovated the buttons Fixed hydraulic system Replace sensor

Change one sensor

Change the oil Replace welding tape Change silicone strip Replace lid seal Vacuum value 7

Test drive and review

Replaced start, stop button and lamp. Welded and fixed the blade guide under the table. New protective ball bearing behind the blade.

Test drive works great. Very little use, mint condition.

New input and output bands New knife Works perfectly

Installed another vacuum pump. Directed hook Fixed the twister Going well 👍

Made missing press tools Change a button Rust-protected misc. Inside Welded feet.

Replaced packing boxes in the mixer gearbox Welded mixer arm Fixed bushing for mixer arm Painted engines and gearboxes

All advanced control is disconnected. Slice thickness is controlled by air-pressured control

Mounted cutoff on-off Replace main power switch Renovated welding beam The machine runs with an external vacuum pump or central vacuum (pump not included, can be purchased separately) Welding beam: 80x70cm The conveyor belt is included

All buttons replaced A contactor replaced Manufacturing miscellaneous Levers, etc Test drive

Frying /Fryer/Cooking - top condition! Barely used, has been in warm storage. "With VarioCooking Center MULTIFICIENCY®, Frima VCC you can cooking, roasting, roasting, low-temperature cooking, confectionery, sous-vide cooking... without supervision, without burning, without the stress of handling pots and pans."

Painted engine compartment Renovated electrical cabinet Review light curtain, one light curtain replaced with a new one. New start and stop buttons. Installed new engine Change the gaskets in one of the mixer arms.

Changed thermo cable to sensor for electric cartridges. Change vacuum oil Replace compressed air filter 4-5 pallets of trays are included
Moulds: 140x220, 140x250mm

Overhauled works good Trough: 160x230mm

New shaft + bearing slave side conveyor belt. 3 new heating cartridges. New feeder cable. New door for electrical cabinet. New inlet and outlet curtains

Replace air distributor Replace welding tape Change the oil Fixed connectors for pinch protection Double weld + cut off

Test run OK

Painted engine and gearbox New side plastic New curtain Works well

Test run OK Variable lifting height 140-200cm

Test drive and review Works perfectly

Testrun good working order