Changed thermo cable to sensor for electric cartridges. Change vacuum oil Replace compressed air filter 4-5 pallets of trays are included
Moulds: 140x220, 140x250mm

Overhauled works good Trough: 160x230mm

New shaft + bearing slave side conveyor belt. 3 new heating cartridges. New feeder cable. New door for electrical cabinet. New inlet and outlet curtains

Test driven ok Trough: 140x205mm

Replace air distributor Replace welding tape Change the oil Fixed connectors for pinch protection Double weld + cut off

Test run OK

Change the oil Replace welding tape Change silicone strip Replace lid seal Vacuum value 7

Test run and adjusted welding times Works well Tube dimension: 156mm Welding width: 25cm Front cup missing, sensor bridged

Serviced vacuum pump Tool 150x195mm

Adjusted film tensioner. Lubricated buttons. Change the lower part of the plastic suction cup. Installed new air hoses. Replaced bellows + adjusted knife. Tools, 15x31cm (2 compartments)

Test run OK Trough: 190x140mm

Repaired Potentiometer Change cover gasket Change oil and filter Works well Vac value 6mbar